Steering Wheel Audio Remote Control Switch Check
WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
Use an ohmmeter to measure the resistance value between the terminal.
RESISTANCE SPECIFICATIONS
| Switch Position | Tester Connection | Measurement Value |
|---|---|---|
| No push | 2 - 3 | Approximately 3.1 kΩ |
| 2 - 4 | Approximately 71 kΩ | |
| "Mode" switch | Approximately 270 Ω | |
| "CH up" switch | Approximately 740 Ω | |
| "CH down" switch | Approximately 1.3 kΩ | |
| "VOL up" switch | Approximately 2.1 kΩ | |
| "VOL down" switch | Approximately 3.1 kΩ |
On the steering wheel audio remote control switch connector, check the continuity between terminals.