LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Windshield Wiper System And Washer System - Lancer Evolution) >> Windshield Wiper >> Inspection >> Windshield Wiper Motor At Stop Position Operation

Windshield Wiper Motor At Stop Position Operation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the battery to the windshield wiper motor as shown in the illustration (A).
  2. Run the windshield wiper motor at low speed, then disconnect the battery in the middle of the motor rotation and check to see that the motor stops.
  3. Connect the battery to the windshield wiper motor as shown in the illustration (B).
  4. Connect the terminals of the windshield wiper motor connector as shown in the illustration (B).
  5. Check to see that the windshield wiper motor runs at low speed and then stops at the automatic stop position.
    Fig 1: Checking Windshield Wiper Motor Operation (Stop Position Check)
    G05384544Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals