Trouble Symptom Chart

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

TROUBLE SYMPTOM CHART

TROUBLE SYMPTOM	Inspection procedure
The windshield wipers do not work at all.	Refer to INSPECTION PROCEDURE 1: THE WINDSHIELD WIPERS DO NOT WORK AT ALL.
The windshield wipers do not work when the wiper switch is at the "INT", "Washer" or "Mist" position. However, the wipers work at low speed when the switch is at the "Lo" or "Hi" position.	Refer to INSPECTION PROCEDURE 2: THE WINDSHIELD WIPERS DO NOT WORK WHEN THE WIPER SWITCH IS AT THE "INT", "WASHER" OR "MIST" POSITION. HOWEVER, THE WIPERS WORK AT LOW SPEED WHEN THE SWITCH IS AT THE "LO" OR "HI" POSITION.
Windshield wipers do not stop at the specified park position.	Refer to INSPECTION PROCEDURE 3: WINDSHIELD WIPERS DO NOT STOP AT THE SPECIFIED PARK POSITION.
Windshield wipers do not work normally.	Refer to INSPECTION PROCEDURE 4: WINDSHIELD WIPERS DO NOT WORK NORMALLY.
The windshield intermittent wiper interval cannot be adjusted by operating the windshield intermittent wiper volume control switch.	Refer to INSPECTION PROCEDURE 5: THE WINDSHIELD INTERMITTENT WIPER INTERVAL CANNOT BE ADJUSTED BY OPERATING THE WINDSHIELD INTERMITTENT WIPER INTERVAL CONTROL SWITCH.
The windshield intermittent wiper interval is not changed according to the vehicle speed.	Refer to INSPECTION PROCEDURE 6: THE WINDSHIELD INTERMITTENT WIPER INTERVAL IS NOT CHANGED ACCORDING TO THE VEHICLE SPEED.
The rain sensitive AUTO wiper function does not work at all <Vehicles with lighting control sensor>.	Refer to INSPECTION PROCEDURE 7: THE RAIN SENSITIVE AUTO WIPER FUNCTION DOES NOT WORK AT ALL <VEHICLES WITH LIGHTING CONTROL SENSOR>.
The rain sensitive AUTO wiper function works even though there is no rainfall <Vehicles with lighting control sensor>.	Refer to INSPECTION PROCEDURE 8: THE RAIN SENSITIVE AUTO WIPER FUNCTION WORKS EVEN THOUGH THERE IS NO RAINFALL <VEHICLES WITH LIGHTING CONTROL SENSOR>.
Sometimes the rain sensitive AUTO wiper function works even though there is no rainfall <Vehicles with lighting control sensor>.	Refer to INSPECTION PROCEDURE 9: SOMETIMES THE RAIN SENSITIVE AUTO WIPER FUNCTION WORKS EVEN THOUGH THERE IS NO RAINFALL <VEHICLES WITH LIGHTING CONTROL SENSOR>.
The windshield washer does not work normally.	Refer to INSPECTION PROCEDURE 10: THE WINDSHIELD WASHER DOES NOT WORK NORMALLY.
The intelligent washing function does not work normally.	Refer to INSPECTION PROCEDURE 11: THE INTELLIGENT WASHING FUNCTION DOES NOT WORK NORMALLY.
Delayed finishing wipe function does not work normally	Refer to INSPECTION PROCEDURE 12: DELAYED FINISHING WIPE FUNCTION DOES NOT WORK NORMALLY.

NOTE: Even when the ETACS-ECU has failed, the windshield wipers can work at low speed as fail-safe mode.