Trouble Judgment
WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
The theft-alarm sensor communicates with the ETACS-ECU via the LIN bus line. If the diagnostic trouble code No. B120B is set, the theft-alarm sensor itself may be defective.
NOTE:
- Diagnostic trouble code No. B120B may be set when the theft-alarm sensor cover is improperly installed or is removed. Check if the theft-alarm sensor cover is properly installed.
- Diagnostic trouble code No. B120B is set when the ultrasonic wave transmission/reception part of the theft-alarm sensor is covered. Check if the ultrasonic wave transmission/reception part of the theft-alarm sensor was covered.