Camber, Caster And Kingpin Inclination: Caster
WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
Standard value:
4°25' ± 0°30' (Left/right deviation within 0°30')
Kingpin inclination 13°50' ± 1°30'
NOTE:
Camber and caster are preset at the factory and cannot be adjusted.
CAUTION:
Do not apply the vehicle weight to the wheel bearing with the driveshaft nut loosened.
NOTE:
Tighten the wheel alignment gauge attachment (special tool: MB991004) to the specified torque, then perform measurement.
Tightening torque: 225 ± 25 N.m (184 ± 18 ft-lb)