Diagnostic Procedure

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Scan tool CAN bus diagnostics
Using scan tool MB991958, diagnose the CAN bus lines.

Q: Is the check result normal?

YES : Go to Step 3.

NO : Repair the CAN bus lines. (Refer to TROUBLESHOOTING .) After repairing the CAN bus line, go to Step 2.
STEP 2. Check whether the DTC is reset.
Q: Is DTC No. C1622 set?

YES : Go to Step 3.

NO : This diagnosis is complete.
STEP 3. Scan tool diagnostic trouble code
Check other AWC diagnostic trouble code.(Refer to DIAGNOSTIC TROUBLE CODE CHART .)

Q: Is the DTC set?

YES : Perform the relevant troubleshooting.

NO : Go to Step 4.
STEP 4. Check whether the DTC is reset.
Q: Is DTC No. C1622 set?

YES : Replace the AWC-ECU.(Refer to AWC-ECU .) Then go to Step 5.

NO : This diagnosis is complete. (The clutch protection activated in such driving or road condition as ACD control is applied for a prolonged period.)
STEP 5. Check whether the DTC is reset.
Q: Is DTC No. C1622 set?

YES : Return to Step 1.

NO : This diagnosis is complete.