LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Manual Transaxle Overhaul - Lancer Evolution) >> Transaxle >> Disassembly And Assembly >> Assembly Service Points >> >>J<< Shift Cable Bracket Installation

>>J<< Shift Cable Bracket Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift cable bracket loosely.
  2. Put the control shaft into neutral.
  3. Position the shift cable bracket so that the distance between the control shaft and shift cable bracket is within the standard value. Then fix the bracket securely.

    Standard value: 154 - 156 mm (6.063 - 6.141 inch) 

    Fig 1: Distance Between Control Shaft & Shift Cable Bracket
    G06676963Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  4. Install the select lever bracket loosely.
  5. Put the select lever into the 3rd-4th speed position.
  6. Position the select lever bracket so that the distance between the select lever and shift cable bracket is within the standard value. Then fix the bracket securely.

    Standard value: 139.2 - 140.8 mm (5.481 - 5.543 inch) 

    Fig 2: Distance Between Select Lever & Shift Cable Bracket
    G06676964Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals