LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Manual Transaxle Overhaul - Lancer Evolution) >> Transaxle >> Disassembly And Assembly >> Assembly Service Points >> >>H<< Control Housing Installation

>>H<< Control Housing Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Completely degrease the FIPG-applied surface so that water and oil including the old sealant cannot adhere to the surface coated with the sealant.

    Never touch the degreased surface by hand.

  2. Apply a bead (approximately 3.5 mm (0.14 inch) thick) of specified sealant to the control housing as shown in illustration.

    Specified sealant: Mitsubishi Part No. MD997740 or equivalent 

    Fig 1: Sealant Applying Area On Control Housing
    G05393963Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals