LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Manual Transaxle Overhaul - Lancer Evolution) >> Transaxle Case >> Disassembly And Assembly >> Assembly Service Points >> >>E<< Slide Ball Bearing (For Shift Rail) Installation

>>E<< Slide Ball Bearing (For Shift Rail) Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Normally, it is not necessary to disassemble the slide ball bearing. Install it only when the transaxle case is replaced with a new one.
  • Install the bearing with the stamped mark facing upward.

Using special tool, MB990883, install the slide ball bearing (for shift rail) to the new transaxle case.

Fig 1: Installing Slide Ball Bearing To Transaxle Case Using Special Tool MB990883
G05394053Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals