LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Manual Transaxle Overhaul - Lancer Evolution) >> Output Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>D<< 1ST-2ND Speed Synchronizer Sleeve Installation

>>D<< 1ST-2ND Speed Synchronizer Sleeve Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the 1st-2nd speed synchronizer sleeve in the illustrated direction.
  2. Install the synchronizer outer ring, synchronizer cone and synchronizer inner ring.
  3. After installation, check that the 1st-2nd speed gears rotate smoothly.
    Fig 1: 1st-2nd Speed Synchronizer Sleeve Installation Direction
    G05394005Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals