LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Manual Transaxle Overhaul - Lancer Evolution) >> Input Shaft >> Disassembly And Assembly >> Assembly Service Points >> >>C<< 3RD-4TH Speed Synchronizer Hub/3RD-4TH Speed Synchronizer Sleeve Installation

>>C<< 3RD-4TH Speed Synchronizer Hub/3RD-4TH Speed Synchronizer Sleeve Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the 3rd-4th speed synchronizer hub and synchronizer sleeve in the illustrated direction.
    Fig 1: 3rd-4th Speed Synchronizer Hub & Synchronizer Sleeve Installation Direction
    G05393980Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Using the special tools, MD998812, MD998813 and MD998822, indicated below, install the 3rd-4th speed synchronizer sleeve, 3rd-4th speed synchronizer hub, synchronizer outer ring, synchronizer inner ring and synchronizer cone.
  3. After installation, check that the 3rd speed gear rotates smoothly.
    Fig 2: Special Tools, MD998812, MD998813 & MD998822
    G05393981Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals