LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Clutch Overhaul - Lancer Evolution) >> Clutch Release Cylinder >> Inspection >> Release Cylinder

Release Cylinder

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the bore of the release cylinder for rust, scratches or damage.
  2. Using a cylinder gauge, measure the inside diameter of the release cylinder at about three positions (the deepest, middle and brim positions). If the clearance from the outside diameter of the piston exceeds the limit, replace the release cylinder as an assembly.

    Limit: 0.15 mm (0.006 inch) 

scientia non olet · About LEMON Manuals