LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Clutch Overhaul - Lancer Evolution) >> Clutch Release Cylinder >> Disassembly And Assembly >> Assembly Service Point >> >>A<< Piston Cup/Piston Installation

>>A<< Piston Cup/Piston Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply brake fluid to the entire inner surface of the release cylinder.

    Specified brake fluid: Brake fluid DOT 3 or DOT 4 

    Fig 1: Applying Brake Fluid To Entire Inner Surface Of Release Cylinder
    G05393863Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Apply grease to the piston and piston cups and insert the piston assembly into the release cylinder.

    Specified grease: Rubber grease 

    Fig 2: Applying Grease To Piston & Piston Cups
    G05393864Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals