LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Front Axle - Lancer Evolution) >> On-Vehicle Service >> Wheel Bearing End Play Check

Wheel Bearing End Play Check

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front caliper assembly and front disk brake, and retain the front caliper assembly with a wire and the like to prevent from falling (Refer to FRONT AXLE HUB ASSEMBLY  ).
  2. Set a dial gauge as shown in the illustration. Move the hub in the axial direction and measure the end play.

    Limit: 0.05 mm (0.002 inch) 

  3. After checking, install the front brake disk and the front caliper assembly (Refer to FRONT AXLE HUB ASSEMBLY  ).
    Fig 1: Measuring End Play While Moving Hub In Axial Direction
    G04231680Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals