LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Parking Brakes - Lancer Evolution) >> Parking Brake Cable >> Removal And Installation >> Installation Service Point >> >>A<< Parking Brake Rear Cable Connection Installation

>>A<< Parking Brake Rear Cable Connection Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Check that the equalizer and the parking brake rear cable are connected correctly. If the parking brake is applied with the equalizer and the parking brake rear cable connected improperly, the equalizer may be damaged.
  1. Connect the parking brake rear cable to the equalizer as shown in illustration.
    Fig 1: Connecting Parking Brake Rear Cable To Equalizer
    G07034017Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Connect the parking brake rear cable, and tighten the floor console bracket rear mounting bolt to the specified torque.

    Tightening torque: 9.5 ± 3.5 N.m (84 ± 30 in-lb) 

    Fig 2: Parking Brake Rear Cable Connection With Torque Specifications
    G05394744Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals