Diagnostic Trouble Code Chart < Occupant Classification-Ecu >
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
During diagnosis, a DTC code associated with another system may be set when the ignition switch is turned on with connector(s) disconnected. After completing the repair, confirm all systems for DTC code(s). If DTC code(s) are set, erase them all.
Inspect according to the inspection chart that is appropriate for the DTC.
DIAGNOSTIC TROUBLE CODE CHART
| DTC No. | Inspection item |
|---|---|
| B1B78 | Passenger seat weight sensor (front: LH) performance |
| B1B79 | Passenger seat weight sensor (ground side) short-circuited (front: LH) |
| B1B7A | Passenger seat weight sensor (power supply side) short-circuited or open (front: LH) |
| B1B7D | Passenger seat weight sensor (front: RH) performance |
| B1B7E | Passenger seat weight sensor (ground side) short-circuited (front: RH) |
| B1B7F | Passenger seat weight sensor (power supply side) short-circuited or open (front: RH) |
| B1B82 | Passenger seat weight sensor (rear: LH) performance |
| B1B83 | Passenger seat weight sensor (ground side) short-circuited (rear: LH) |
| B1B84 | Passenger seat weight sensor (power supply side) short-circuited or open (rear: LH) |
| B1B87 | Passenger seat weight sensor (rear: RH) performance |
| B1B88 | Passenger seat weight sensor (ground side) short-circuited (rear: RH) |
| B1B89 | Passenger seat weight sensor (power supply side) short-circuited or open (rear: RH) |
| B1B8C | Seat slide sensor circuit performance |
| B1B8D | Seat slide sensor open circuit |
| B1B8E | Seat slide sensor (power supply side) short circuit |
| B1B91 | Driver seat slide sensor configuration mismatch |
| B1BA7 | Occupant classification system verification required |
| B1BA8 | Occupant classification-ECU out of calibration/Not calibrated |
| B1BBA | Passenger seat weight sensor power supply circuit |
| B1BBC | Occupant classification system negative system weight |
| B1BBD | Occupant classification - ECU Current configuration table unprogrammed |
| B1C23 | Passenger seat weight sensor (front: LH) configuration mismatch |
| B1C24 | Passenger seat weight sensor (front: RH) configuration mismatch |
| B1C25 | Passenger seat weight sensor (rear: LH) configuration mismatch |
| B1C26 | Passenger seat weight sensor (rear: RH) configuration mismatch |
| B1CB2 | Occupant classification-ECU parameter table incompatible |
| B210D | Battery voltage Low |
| B210E | Battery voltage High |
| B2206 | Chassis number does not match |
| B2212 | Occupant classification-ECU internal failure |
| B2250 | Occupant classification-ECU not programmed/Flash required |
| B2262 | Occupant classification-ECU electrostatic discharge event detected |
| U0020 | CAN-B Bus off performance |
| U0021 | CAN-B Bus (HI) circuit open |
| U0022 | CAN-B Bus (HI) shorted to circuit ground |
| U0023 | CAN-B Bus (HI) shorted to circuit power supply |
| U0024 | CAN-B Bus (LO) circuit open |
| U0025 | CAN-B Bus (LO) shorted to circuit ground |
| U0026 | CAN-B Bus (LO) shorted to circuit power supply |
| U0141 | ETACS CAN timeout |
| U0151 | SRS-ECU CAN timeout |
| U0155 | Combination meter CAN timeout |
| U0164 | A/C-ECU CAN timeout |
| U0168 | KOS-ECU or WCM CAN timeout |
| U0184 | Audio CAN timeout |
| U0195 | Satellite radio tuner CAN timeout |
| U0197 | Hands free module CAN timeout |
| U0245 | Audio visual navigation unit CAN timeout |
| U1419 | The signal from a weight sensor (front: LH) is unusual |
| U141A | The signal from a weight sensor (front: RH) is unusual |
| U141B | The signal from a weight sensor (rear: LH) is unusual |
| U141C | The signal from a weight sensor (rear: RH) is unusual |
| U1423 | The signal from a weight sensor is unusual |