LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Supplemental Restraint System (SRS) -- Lancer Evolution) >> Front Impact Sensors >> Removal And Installation >> Installation Service Points >> >> C << Post-Installation Inspection

>> C << Post-Installation Inspection

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Reconnect the negative (-) battery cable.
  2. Turn the ignition key to "ON" position.
  3. Does the "SRS" warning light illuminate for approximately seven seconds, and then go out?
  4. If yes, the SRS system is functioning properly.

    If not, consult page DIAGNOSTIC TROUBLE CODE CHART < SRS-ECU >  .

    Fig 1: Identifying SRS Warning Light
    G05396571Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.