LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Trunk Lid - Lancer Evolution) >> On-Vehicle Service >> Trunk Lid Height Adjustment >> Adjustment At Trunk Lid Hinge-Side

Adjustment At Trunk Lid Hinge-Side

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

If the height between the trunk lid and the body is uneven, adjust the height in the following manner.

  1. Remove the trunk lid damper on the trunk lid hinge.
    CAUTION: Up to maximum 3 washers can be used.
  2. Increase or decrease the number of washers until the even height between the trunk lid and the body can be obtained.
  3. Tighten the trunk lid damper.

    Specified torque: 5.0 ± 1.0 N.m (44 ± 8 in-lb) 

    Fig 1: Identifying Trunk Lid Hinge & Washer
    G05394975Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals