LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Trunk Lid - Lancer Evolution) >> On-Vehicle Service >> Trunk Lid Height Adjustment >> Adjustment At Body-Side

Adjustment At Body-Side

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

If the height between the trunk lid and the body is uneven, adjust the height in the following manner.

  1. Loosen the body-side trunk lid hinge mounting bolts.
  2. Adjust the height.
  3. Tighten the hinge mounting bolts

    Specified torque: 23 ± 6 N.m (17 ± 4 ft-lb) 

    Fig 1: Identifying Trunk Lid Hinge
    G05384191Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals