Door Window Glass Adjustment

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Check that the door glass operates smoothly and moves along the door glass run channel when the door window glass is fully raised and fully lowered. If there is a problem, adjust by the following procedure.

Fig 1: Channel Guide Mounting Bolt To Adjusting Hole (Front Door)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Remove the door trim assembly (Refer to DOOR TRIM ).
Remove the waterproof film (Refer to WINDOW GLASS RUNCHANNEL AND DOOR OPENING WEATHERSTRIP ).
Remove the grommet from the adjusting hole <Vehicles with 9 speakers (Rockford Fosgate® premium sound system)>.
Remove the power window switch from the removed door trim, and connect it to the connector, then set the channel guide mounting bolt to the adjusting hole. (Refer to DOOR GLASS AND REGULATOR ).
Raise the door window glass and loosen the channel guide mounting bolts to adjust tilting up/down of the glass.

Fig 2: Channel Guide Mounting Bolt To Adjusting Hole (Rear Door)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.