LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Door System - Lancer Evolution) >> On-Vehicle Service >> Door Inside Handle Check >> Door Inside Handle Lock Knob Stroke Check

Door Inside Handle Lock Knob Stroke Check

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door trim assembly (Refer to DOOR TRIM ).
  2. Check that the stroke of the door inside handle lock knob meets the standard value.

    Standard value (B): 13.7 - 15.0 mm (0.54 - 0.59 inch) [Target value: 14.7 mm (0.58 inch)] 

    Fig 1: Checking Door Inside Handle Lock Knob Stroke
    G05384155Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  3. If it is outside the standard value, adjust the stroke of the inside handle lock knob by using the outer cable end, which connects the inside handle lock knob to the inside lock cable.
    Fig 2: Door Inside Handle & Inside Lock Cable
    G05384156Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals