LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Power Steering - Lancer Evolution) >> Steering Shaft >> Removal And Installation >> Installation Service Points >> >>A<< Steering Column Shaft Assembly Installation

>>A<< Steering Column Shaft Assembly Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure that the tilt lever is in the lock position.
  2. Temporarily tighten the mounting bolts in the order of a, b, and c, and then tighten them in the order of c, b, and a to the specified torque.

    Tightening torque a: 28 ± 7 N.m (21 ± 5 ft-lb) 

    Tightening torque b, c: 12 ± 3 N.m (106 ± 27 in-lb) 

    Fig 1: Locating Steering Column Shaft Assembly Mounting Bolts A, B & C
    G05394798Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals