LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Power Steering - Lancer Evolution) >> Power Steering Gear Box And Linkage >> Disassembly And Assembly >> Assembly Service Point >> >>C<< Tie-Rod End/Jam Nut Installation

>>C<< Tie-Rod End/Jam Nut Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Screw in the tie-rod to the length shown in the illustration, and hand-tighten the locking nut.

NOTE: Install the steering gear and linkage to the body, adjust the toe-in, and then tighten the jam nut to the specified torque.
Fig 1: Identifying Tie-Rod Standard Value
G06677738Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals