LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Active Stability Control System (ASC) - Lancer Evolution) >> On-Vehicle Service >> Hydraulic Unit Check >> Hydraulic Unit Installation Adjustment

Hydraulic Unit Installation Adjustment

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Refer to HYDRAULIC UNIT .

  1. Operate the pre-removal steps for the hydraulic unit.
  2. Remove all brake tubes.
  3. Remove the protector.
  4. Loosen the mounting bolt and nut of the hydraulic unit bracket.
  5. Install all brake tubes temporarily.
  6. Shake hydraulic unit to all directions with both hands to make the hydraulic unit bracket insulator fit with the unit.
  7. Install the hydraulic unit bracket with mounting bolt and nut not to load the brake tube.
  8. Install the protector.
  9. Install all brake tubes securely.
    NOTE: Install the flare nut taking care not to let the brake tube turn together.
  10. Operate the post-installation steps of the hydraulic unit.
scientia non olet · About LEMON Manuals