LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (Manual Transaxle On-Vehicle Service - Lancer Evolution) >> On-Vehicle Service >> Transfer Oil Change

Transfer Oil Change

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine room under cover front B assembly. (Refer to UNDER COVER .)
  2. Remove the drain plug and gasket to drain the oil.
  3. Install the drain plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  4. Remove the filler plug and gasket, then fill the oil up to the lower edge of the filler plug hole.

    Brand name: DiaQueen LSD gear oil 

    Quantity: 0.8 dm 3  (0.85 quarts) 

    Fig 1: Identifying Oil Filler Plug & Oil Drain Plug
    G06676886Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Install the filler plug and new gasket, then tighten them to the specified torque.

    Tightening torque: 32 ± 2 N.m (24 ± 1 ft-lb) 

  6. Install the engine room under cover front B assembly. (Refer to UNDER COVER .)
    Fig 2: Identifying Filler Plug Hole, Filler Plug & Gasket
    G06676889Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals