Hub Bolt Replacement

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Required Special Tools:

MB990767: Front Hub and Flange Yoke Holder
MB991618: Hub Bolt Remover

Remove the rear brake disk. (Refer to PARKING BRAKE LINING AND DRUM ).
Use special tool MB991618 to remove the hub bolts.

Fig 1: Removing Hub Bolts
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Install the plain washer to the new hub bolt, and install the bolt with a nut while holding the hub with special tool MB990767.
Install the rear brake disk. (Refer to PARKING BRAKE LINING AND DRUM ).

Fig 2: Holding Hub With Special Tool MB990767
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.