>>F<< Turbocharger Compressor Bracket Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Check that the turbocharger compressor bracket is in close contact with the turbocharger assembly and with the cylinder block, and then temporarily tighten the turbocharger compressor bracket.

Fig 1: Identifying Turbocharger Compressor Bracket & Cylinder Block
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Use special tool MB992274 to tighten the turbocharger compressor bracket mounting bolt (cylinder block side) to the specified torque.
Tightening torque: 51 ± 7 N.m (38 ± 5 ft-lb)
Tighten the bolt of the turbocharger assembly side to the specified torque.
Tightening torque: 51 ± 7 N.m (38 ± 5 ft-lb)

Fig 2: Identifying Turbocharger Compressor Bracket Mounting Bolt (Cylinder Block Side)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.