LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Engine Lubrication - Lancer Evolution) >> Oil Pump >> Removal And Installation >> Installation Service Point >> >>A<< Engine Oil Pump Sprocket Center Bolt Installation

>>A<< Engine Oil Pump Sprocket Center Bolt Installation

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine oil pump sprocket in the engine oil pump assembly while the engine oil pump sprocket is installed in the engine oil pump drive chain.
  2. Hold the engine oil pump sprocket with special tool MB991346 in the same manner as removal.
  3. Tighten the engine oil pump sprocket center bolt to the specified torque.

    Tightening torque: 23 ± 2 N.m (17 ± 1 ft-lb) 

  4. Remove the tie-wrap securing the engine oil pump sprocket and engine oil pump drive chain to prevent the slippage between them.
    Fig 1: Holding Engine Oil Pump Sprocket With Special Tool MB991346
    G05374203Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals