>>B<< Engine Oil Pump Sprocket/Engine Oil Pump Drive Chain/Engine Oil Pump Sprocket Center Bolt Installation
WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- Set the number 1 cylinder to the top dead center of compression.
- Install the engine oil pump sprocket to the engine oil pump drive chain.
- Install the engine oil pump drive chain in the crankshaft sprocket while the engine oil pump sprocket is installed in the engine oil pump drive chain.
- Install the engine oil pump sprocket in the engine oil pump assembly while the engine oil pump sprocket is installed in the engine oil pump drive chain.
- Hold the engine oil pump sprocket with special tool MB991346 in the same manner as removal.
- Tighten the engine oil pump sprocket center bolt to the specified torque.
Tightening torque: 23 ± 2 N.m (17 ± 1 ft-lb)