>>E<< Thrust Camshaft Bearing Cap/Camshaft Bearing Cap/Oil Feeding Camshaft Bearing Cap Installation
WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the camshaft bearing caps to the cylinder heads.NOTE: Because the thrust camshaft bearing cap and camshaft bearing cap are the same in shape, check the cap number and additionally its symbol to identify the intake and exhaust sides for correct installation.
- Tighten each camshaft bearing cap to the specified torque in the order of number shown in the illustration in two or three steps.
Tightening torque: 12 ± 1 N.m (107 ± 8 in-lb)