Drive Belt Tension Check
WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the radiator condenser tank. (Refer to
RADIATOR
).CAUTION: Check the drive belt tension after turning the crankshaft clockwise one turn or more.
- Make sure that the indicator mark on the auto-tensioner is within the area marked with A in the illustration.
- If the mark is out of the area A, replace the drive belt (Refer to <<A>> DRIVE BELT REMOVAL
).NOTE: The drive belt tension check is not necessary as the auto-tensioner is adopted.
- Install the radiator condenser tank. (Refer to RADIATOR ).