Trouble Symptom Chart For Input Signal

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

TROUBLE SYMPTOM CHART

Trouble symptom	Inspection Procedure
Malfunction of the ignition switch (ACC) input/output signal	Refer to INSPECTION PROCEDURE 1: MALFUNCTION OF THE IGNITION SWITCH (ACC) INPUT/OUTPUT SIGNAL
Malfunction of the ignition switch (IG1) input/output signal	Refer to INSPECTION PROCEDURE 2: MALFUNCTION OF THE IGNITION SWITCH (IG1) INPUT/OUTPUT SIGNAL
ETACS-ECU does not receive any signal from the key reminder switch.	Refer to INSPECTION PROCEDURE 3: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE KEY REMINDER SWITCH.
ETACS-ECU does not receive any signal from the front door lock actuator.	Refer to INSPECTION PROCEDURE 4: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE FRONT DOOR LOCK ACTUATOR.
ETACS-ECU does not receive any signal from the front door switch (LH).	Refer to INSPECTION PROCEDURE 5: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE FRONT DOOR SWITCH (LH).
ETACS-ECU does not receive any signal from the front door switch (RH).	Refer to INSPECTION PROCEDURE 6: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE FRONT DOOR SWITCH (RH).
ETACS-ECU does not receive any signal from the rear door switch (LH).	Refer to INSPECTION PROCEDURE 7: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE REAR DOOR SWITCH (LH).
ETACS-ECU does not receive any signal from the rear door switch (RH).	Refer to INSPECTION PROCEDURE 8: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE REAR DOOR SWITCH (RH).
ETACS-ECU does not receive any signal from the trunk lid latch.	Refer to INSPECTION PROCEDURE 9: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE TRUNK LID LATCH.
ETACS-ECU does not receive any signal from the hazard warning light switch.	Refer to INSPECTION PROCEDURE 10: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE HAZARD WARNING LIGHT SWITCH.
ETACS-ECU does not receive any signal from the column switch signal.	Refer to INSPECTION PROCEDURE 11: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE COLUMN SWITCH SIGNAL.
ETACS-ECU does not receive any signal from the hood switch.	Refer to INSPECTION PROCEDURE 12: ETACS-ECU DOES NOT RECEIVE ANY SIGNAL FROM THE HOOD SWITCH.