<< B >> Fuel High-Pressure Hose Disconnection

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Follow the steps below to unlock the fuel high-pressure hose connector.

Fig 1: Identifying Fuel High-Pressure Hose Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
1. Insert a flat-tipped screwdriver [6 mm (0.24 inch) wide and 1 mm (0.04inch) thick] into the retainer of the fuel high-pressure hose connector.
  CAUTION: When pushing up the retainer of the fuel high-pressure hose connector, pay attention to avoid damage to the retainer.
  
  Fig 2: Inserting Flat-Tipped Screwdriver Wide To Retainer Of Fuel High-Pressure Hose Connector
  Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
2. Turn the flat-tipped screwdriver inserted into the retainer by 90 degrees to push up the retainer and unlock the fuel high-pressure hose connector.
Remove the fuel high-pressure hose.

Fig 3: Pushing Up Retainer And Fuel High-Pressure Hose Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.