LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Cooling - Lancer Evolution) >> Water Hose And Water Pipe >> Removal And Installation >> Installation Service Points >> >> B << Fuel High-Pressure Hose Connection

>> B << Fuel High-Pressure Hose Connection

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • When pushing in the retainer of the fuel high-pressure hose connector, pay attention to avoid damage to the retainer.
  • After the installation of the fuel high-pressure hose, slightly pull the fuel high-pressure hose to check that it is connected securely. At this time, also check that there is approximately 1 mm (0.04inch) play.
  1. Securely insert the fuel rail stopper into the fuel high-pressure hose connector groove to install the fuel high-pressure hose to the fuel rail.
  2. Push in the retainer of the fuel high-pressure hose connector to lock the fuel high-pressure hose and fuel rail.
    Fig 1: Identifying Fuel High-Pressure Hose Connection
    G05393641Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals