LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (General - Electrical - Lancer Evolution) >> How To Diagnose >> Checking Switches

Checking Switches

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

In a circuit diagram, a switch is shown in the idle state.

  1. Normally open or normally closed switch

    Switches are classified into those which open the circuit and those which close the circuit when off.

    Switches are shown in their normal state unless specified otherwise.

    Fig 1: Current Flow Of Normally Open Or Normally Closed Switch
    G06676616Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Switch connection

    The illustration below shows a complex switch. The continuity between terminals at each position is as indicated in the table below.

    TERMINALS CONTINUITY REFERENCE CHART

    SWITCH POSITION TESTER CONNECTION SPECIFIED CONDITION
    OFF - -
    1st stage 1-5-6 Continuity
    2nd stage 1-4-6 Continuity
    3rd stage 1-3-6 Continuity
    4th stage 1-2-6 Continuity
    Fig 2: Complex Switch Diagram
    G06676617Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.