Injector Connector

WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the waterproof cap.

Fig 1: Removing Waterproof Cap
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Insert the tip of a screwdriver [1.4 mm (0.06 inch) width] into the connector as shown in the illustration, press in the terminal lance, and pull out the terminal.

Fig 2: Inserting Tip Of Screwdriver Into Injector Connector
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

CAUTION: Make sure the lance is pressed in before the terminal is inserted into the connector.
Press the contact point to the male terminal down by holding a screwdriver [1.4 mm (0.06 inch) width] as shown in the illustration.

Fig 3: Pressing Contact Point To Male Terminal Down By Holding Screwdriver
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.