24. Rear Axle Oil (For Torque Transfer Mechanism Part) (Change)
WARNING: This page is about a different car, the 2012 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the filler plug.
- Remove the drain plug and drain oil.
- Install the drain plug, and tighten it to the specified torque.
Tightening torque: 32 ± 2 N.m (23 ± 2 ft-lb)
- Fill the specified gear oil up to the bottom of the filler plug hole.
Specified gear oil: DIAMOND ATF-SP III
Amount to use: 0.55 ± 0.60 dm 3 (0.58 ± 0.63 qt)
- Install the filler plug, and tighten it to the specified torque.
Tightening torque: 49 ± 10 N.m (37 ± 7 ft-lb)