< Confirming Proper Balance >
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
- After balancing the wheel, loosen the wing nut and turn the wheel 180 degree angle against the balancer's hub. Then retighten the wing nut and check the balance again. Repeat wheel balance if necessary.
- Turn the wheel again 180 degree angle against the balancer's hub. If the wheel becomes out-of-balance each time it is turned against the balancer's hub, the wheel balancer may require calibration.