LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Rear Suspension & Wheel Alignment - Lancer Evolution) >> Shock Absorber Assembly >> Disassembly And Assembly >> Assembly Service Points >> >> A << Coil Spring Installation

>> A << Coil Spring Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coil spring end as shown in the figure, so that it should face the vehicle rearward.
    Fig 1: Identifying Shock Absorber
    G05376228Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  2. Set the shock absorber to special tools: MB991793, MB991796, MB991794 and MB991830, and slowly compress the coil spring while guiding the shock absorber piston rod through the hole on the upper spring bracket by hand:
    NOTE: Use the bolts and nuts removed from the vehicle to secure the shock absorber assembly and tighten them lightly by hand.
    Fig 2: Identifying Special Tools
    G05394540Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals