Rear Wheel Alignment Check And Adjustment: Toe-In
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
Standard value: 3 ± 2 mm (0.12 ± 0.08 inch)
It toe-in is not within the standard value, adjust by following procedures.
- Be sure to adjust the camber before making toe adjustment.
Turn the adjusting bolt (toe adjusting bolt: control link mounting bolt which is located on the inner side of the body) to adjust.
Left wheel: Turning clockwise →(+) toe-in
Right wheel: Turning clockwise →(-) toe-in