Control Link Slide Bushing Rotation Starting Torque Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Required Special Tool:

MB990326: Preload socket

Insert the bolt to the control link slide bushing, and install the nuts with the washer from the opposite side. Rotate the inner cylinder (including washer) for several turns, and measure the rotation starting torque of the control link slide bushing using the special tool MB990326.
Standard value: 2.0 (17.7 in-lb) or less

Fig 1: Measuring Rotation Starting Torque Of Control Link Slide Bushing
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
When the measured value exceeds the standard range, replace the control link assembly.
Even if the measured value is within the standard value, check that the control link slide bushing has no looseness or gritty feeling. If there is no looseness or gritty feeling, it is judged as usable.