>> D << Shoe-To-Anchor Spring Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Shoe Adjusting Bolt (Right And Left)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

The shoe-to-anchor springs are not interchangeable because their spring loads are different. The one with blue paint must be installed to the vehicle front, and the other with yellow paint to the vehicle rear.

Fig 2: Identifying Springs Paint Mark (Yellow And Blue)

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.