<< A >> Parking Brake Rear Cable Connection Removal

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the parking brake rear cable according to the procedure below.

Release the parking brake, and loosen the adjusting nut.
Remove the floor console bracket rear mounting bolt.

Fig 1: Locating Floor Console Bracket Rear Mounting Bolt
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Slide the floor console bracket rear, and disconnect the parking brake rear cable through the hole indicated with an arrow in the figure.

Fig 2: Locating Floor Console Bracket Rear
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.