LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2010 >> Lancer ES, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Manual Transaxle Overhaul - Lancer Evolution) >> Clutch Housing >> Disassembly And Assembly >> Assembly Service Points >> >> A << Slide Ball Bearing (For Shift Rail) Installation

>> A << Slide Ball Bearing (For Shift Rail) Installation

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Normally, it is not necessary to disassemble the slide ball bearings. Install them only when the clutch housing is replaced with a new one.
  • Install the bearing with the stamped mark facing upward.

Using special tool, MB990883, install the slide ball bearings on the new clutch housing.

Fig 1: Identifying Slide Ball Bearings On Clutch Housing With Special Tool (MB990883)
G05394039Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals