Snap ring (For adjustment of input shaft rear bearing end play)
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
SNAP RING THICKNESS SPECIFICATION
| Thickness mm (in) |
Thickness mm (in) |
| 1.23 (0.0484) |
1.55 (0.0610) |
| 1.27 (0.0500) |
1.59 (0.0626) |
| 1.31 (0.0516) |
1.63 (0.0642) |
| 1.35 (0.0531) |
1.67 (0.0657) |
| 1.39 (0.0547) |
1.71 (0.0673) |
| 1.43 (0.0563) |
1.75 (0.0689) |
| 1.47 (0.0579) |
1.79 (0.0705) |
| 1.51 (0.0594) |
|