INSPECTION PROCEDURE 6: Squealing, Groaning or Chattering Noise when Brakes are Applied: Diagnosis

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Check the brake disk and pads for wear or cutting.
Q: Is there wear or cutting?

YES : Repair or replace the part. Then go to Step 4.

NO : Go to Step 2.
STEP 2. Check the calipers for rust.
Q: Is there any rust?

YES : Remove the rust. Then go to Step 4.

NO : Go to Step 3.
STEP 3. Adjust the brake pedal.
Refer to BRAKE PEDAL CHECK AND ADJUSTMENT .

Q: Is the brake pedal adjusted correctly?

YES : Go to Step 4.

NO : Adjust the brake pedal. Then go to Step 4.
STEP 4. Recheck symptom.
Q: Is the symptom eliminated?

YES : The procedure is complete.

NO : Start over at Step 1. If a new symptom surfaces, refer to the SYMPTOM CHART .