<< B >> Rear Wheel Hub Assembly Removal

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

If the rear wheel hub assembly is seized with the rear driveshaft assembly, use special tools MB990242 and MB990244, MB991354 and MB990767 to push the rear driveshaft assembly out from the hub and then remove the rear wheel hub assembly.

Fig 1: Removing Rear Wheel Hub Assembly
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If the rear wheel hub assembly is seized with the knuckle, use special tools MB990211 and MB990241 {combination (A)}, or MB990211 and MB991354 {combination (B)} to remove the rear wheel hub assembly.

Fig 2: Identifying Special Tools (MB990211 And MB990241)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Identifying Special Tools (MB990211 And MB991354)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.