Torque Transfer Mechanism Part
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
Required Special Tools:
- MB990938: Installer bar
- MB991551: Bearing outer race installer
- Remove the driveshaft. (Refer to DRIVESHAFT ASSEMBLY .)
- Remove the AYC differential carrier oil seal.
- Use the special tools MB990938 and MB991551 to press-fit a new oil seal.
- Apply specified grease to the oil seal lip and driveshaft oil seal seating area.
Specified grease: Vaseline