<< A >> Wiring Harness Connector Disconnection
WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect the following wiring harness connectors:
CONNECTOR REFERENCE
| Connector number | Connector name |
|---|---|
| D-26 (2 -yellow) | Side impact sensor connector (LH) |
| D-31 (4 -black) | Heated seat assembly connector (LH) < Vehicle with heated seat > |
| D-32 (2 -gray) | Seat slide sensor connector (Driver's seat) |
| D-33 (4 -black) | Seat belt switch connector (Driver's seat) |
| D-34 (2 -yellow) | Side airbag module (squib) connector (LH) < Vehicles with side airbag > |
| D-36 (2 -yellow) | Side airbag module (squib) connector (RH) < Vehicles with side airbag > |
| D-37 (2 -black) | Seat belt switch connector (Passenger's seat) |
| D-38 (4 -black) | Heated seat assembly connector (RH) < Vehicle with heated seat > |
| D-39 (6) | Front seat assembly connector (RH) |
| D-41 (2 -yellow) | Side impact sensor (RH) connector |
NOTE:
When disconnecting the side air bag module connectors of D-34 and D-36, unlock the connector by sliding the locking button to the direction of the arrow as shown in the figure, and then disconnect the connector.