D: Cylinder Head Bolt/Cylinder Head Bolt Washer/Cylinder Head Bolt And Washer Assembly Removal

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.

Temporarily install the engine oil pan which was removed at the valve timing chain removal (Refer to OIL PAN ).
Place a garage jack against the engine oil pan with a piece of wood in between to support the engine and transaxle assembly.
Remove special tool MB991928 or MB991895 which was installed for supporting the engine and transaxle assembly when the valve timing chain was removed.

Fig 1: Identifying Special Tool MB991928 Or MB991895
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Identifying Special Tool MB991928 Or MB991895
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Loosen and remove the bolts in two or three steps in the order of number shown in the figure.

Fig 3: Identifying Cylinder Head Bolt Loosen Sequence
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.